स्टकमा उपलब्ध लोकप्रिय उत्पादन
UST4C11
UST4C11 ST4-C11 PANASONIC Controller for ST4
$0.00USD
3452 स्टकमा
मुख्य विशिष्टताहरू
वस्तु:Specifications
पीएफएचडी:Refer to the following table(Note： (Probability of dangerous failure per hour) depends on number of single beam sensorST4-A□connected to controller.)
MTTFDLanguage:More than 100 years (Note：Mean time to dangerous failure (in years))
तौल:Net weight: 180 g approxGross weight: 390 g approx
आपूर्तिकर्ता जानकारी
PANASONIC
उत्पादहरू: 4316
सामान्यतया २-३ कार्यदिवसभित्र पठाइन्छ
गुणस्तर ग्यारेन्टी
छिटो शिपिङ
प्राविधिक सहयोग
प्राविधिक विशिष्टताहरू
| प्यारामीटर | मूल्य |
|---|---|
| वस्तु | Specifications |
| पीएफएचडी | Refer to the following table(Note： (Probability of dangerous failure per hour) depends on number of single beam sensorST4-A□connected to controller.) |
| MTTFDLanguage | More than 100 years (Note：Mean time to dangerous failure (in years)) |
| तौल | Net weight: 180 g approxGross weight: 390 g approx |
| विवरणहरू | Controller |
| उत्पादन | Compact Type 4 Safety Beam Sensor |
| सामाग्री | Enclosure: ABS |
| भाग नम्बर | ST4-C11 |
| उत्पादनको नाम | Compact Type 4 Safety Beam Sensor ST4 |
| तार जडान गर्ने केबल | Terminal block connector: 0.2 to 1.5 mm2 |
| पावर भोल्टेज | 24 V DC +10-15 % Ripple P-P 10 % or less |
| प्रतिक्रिया समय | OFF response: 25 ms or lessON response: 90 ms or less (auto reset) / 140 ms or less (manual reset) |
| उत्पादन नम्बर | ST4-C11 |
| सहायक आउटपुटहरू | PNP open-collector transistor / NPN open-collector transistor (Set using output polarity selection switch)ST4-C11: one outputST4-C12EX: four outputs[PNP output]Maximum source current: 100 mAApplied voltage: same as the supply voltage (between auxiliary output and +V)Residual voltage: 2.5 V or less (at 100 mA source current)[NPN output]Maximum sink current: 100 mAApplied voltage: same as the supply voltage (between auxiliary output and 0 V)Residual voltage: 2.0 V or less (at 100 mA sink current)(Note) If the total current of the control outputs (OSSD1, OSSD2), auxiliary outputs, and muting lamp output exceeds 400 mA, the wiring resistance between the controller and the power supply should be 1 Ohm or less. In addition, if the total current is 400 mA or less, the wiring resistance between the controller and the power supply should be 2 Ohm or less. |
| बत्तीको आउटपुट म्युट गर्दै | -(Note) If the total current of the control outputs (OSSD1, OSSD2), auxiliary outputs, and muting lamp output exceeds 400 mA, the wiring resistance between the controller and the power supply should be 1 Ohm or less. In addition, if the total current is 400 mA or less, the wiring resistance between the controller and the power supply should be 2 Ohm or less. |
| जडान टर्मिनल | Detachable spring-cage terminal |
| हालको खपत | 100 mA or less (excluding sensor head ST4-Ax) |
| लागू हुने मापदण्डहरू | IEC 61496-1/2 (JIS B 9704-1/2 / UL 61496-1/2) (Type 4), ISO 13849-1:2015 (Category 4, PLe), JIS B 9705-1 (Category 4), IEC 61508-1 to 3 (SIL3), IEC 62061 (SIL3), JIS C 0508-1 to 3 (SIL3), UL 1998, OSHA 1910.212, OSHA 1910.217 (C), ANSI B11.1 to B11.19, ANSI/RIA R15.06, ANSI/ISA S84.01 (SIL3)(Note) Complies with those standards only when the controller is used in combination with the sensor head ST4-x. |
| लागू हुने सेन्सर हेड | ST4-Ax |
| सीई मार्किंग निर्देशन अनुपालन | Machinery Directive, EMC Directive, RoHS Directive |
| सहायक आउटपुटहरू: सञ्चालन मोड | OFF when all beams of the connected ST4-Axs are receivedON when one or more beams of the connected ST4-Axs are interrupted |
| नियन्त्रण आउटपुटहरू (OSSD १, OSSD २) | PNP open-collector transistor / NPN open-collector transistor Dual output x 1 system (Set using output polarity selection switch)[PNP output]Maximum source current: 200 mAApplied voltage: same as the supply voltage (between control output and +V)Residual voltage: 2.5 V or less (at 200 mA source current)Leakage current: 200 micro A or less (including power OFF condition)Maximum load capacity: 1 micro F (from no-load to max. source current)Load wiring resistance: 3 Ohm or less (between control output and load)[NPN output]Maximum sink current: 200 mAApplied voltage: same as the supply voltage (between control output and 0 V)Residual voltage: 2.0 V or less (at 200 mA sink current)Leakage current: 200 micro A or less (including power OFF condition)Maximum load capacity: 1 micro F (from no-load to max. sink current)Load wiring resistance: 3 Ohm or less (between control output and load)(Note) If the total current of the control outputs (OSSD1, OSSD2), auxiliary outputs, and muting lamp output exceeds 400 mA, the wiring resistance between the controller and the power supply should be 1 Ohm or less. In addition, if the total current is 400 mA or less, the wiring resistance between the controller and the power supply should be 2 Ohm or less. |
| सहायक आउटपुटहरू: सुरक्षा सर्किट | Incorporated |
| म्युटिङ ल्याम्प आउटपुट: सुरक्षा सर्किट | Incorporated |
| वातावरणीय प्रतिरोध: परिवेशको आर्द्रता | 30 to 85 % RH, Storage: 30 to 95 % RH |
| वातावरणीय प्रतिरोध: झट्का प्रतिरोध | 300 m/s2acceleration in X, Y and Z directions three times each |
| वातावरणीय प्रतिरोध: परिवेशको तापक्रम | －10 to +55 ℃+14 to +131℉(No dew condensation or icing allowed),Storage: －25 to +70 ℃－13 to +158℉ |
| वातावरणीय प्रतिरोध: सुरक्षाको डिग्री | Enclosure: IP40 (IEC)Terminal: IP20 (IEC) |
| वातावरणीय प्रतिरोध: कम्पन प्रतिरोध | 10 to 55 Hz frequency, 0.75 mm0.030 indouble amplitude or maximum acceleration 90 m/s2 in X, Y and Z directions for two hours each< |
| वातावरणीय प्रतिरोध: इन्सुलेशन प्रतिरोध | 20 MOhm or more with 500 V DC mega between all supply terminals connected together and enclosure |
| नियन्त्रण आउटपुटहरू (OSSD 1, OSSD 2): सञ्चालन मोड | ON when all beams of the connected ST4-Axs are receivedOFF when one or more beams of the connected ST4-Axs are interruptedOFF during lockout |
| लागू हुने सेन्सर हेड: श्रृंखला जडानहरूको संख्या | Interference prevention possible when up to a maximum of 6 sets are connected(When the maximum of 3 controllers are connected together, interference prevention is possible for up to 18 sets) |
| नियन्त्रण आउटपुटहरू (OSSD1, OSSD2): सुरक्षा सर्किट | Incorporated |
| वातावरणीय प्रतिरोध: भोल्टेज सहनशीलता | 1,000 V AC for one min. between all supply terminals connected together and enclosure |
उत्पादन विवरण
Standard Control Unit Safety Barrier Category 4 Ple SIL 3, ST4 Series
मुख्य विशेषताहरू
- औद्योगिक स्तरको गुणस्तर
- RoHS अनुरूप
- सीई प्रमाणित
- १-वर्षीय वारंटी
उत्पादन कागजातहरू
डेटासिट
प्राविधिक विशिष्टताहरू र प्रदर्शन डेटा
प्रयोगकर्ता म्यानुअल
स्थापना र सञ्चालन मार्गनिर्देश
