स्टकमा उपलब्ध लोकप्रिय उत्पादन
UFX505C2
UFX505C2 FX-505-C2 PANASONIC Fiber amplifier, NPN, analogue output, double display
$0.00USD
4554 स्टकमा
मुख्य विशिष्टताहरू
वस्तु:Specifications
केबल:0.2 mm26-core cabtyre cable, 2 m6.562 ftlong
तौल:Net weight: 60 g approx.Gross weight: 100 g approx.
विवरणहरू:Cable type
आपूर्तिकर्ता जानकारी
PANASONIC
उत्पादहरू: 4316
सामान्यतया २-३ कार्यदिवसभित्र पठाइन्छ
गुणस्तर ग्यारेन्टी
छिटो शिपिङ
प्राविधिक सहयोग
प्राविधिक विशिष्टताहरू
| प्यारामीटर | मूल्य |
|---|---|
| वस्तु | Specifications |
| केबल | 0.2 mm26-core cabtyre cable, 2 m6.562 ftlong |
| तौल | Net weight: 60 g approx.Gross weight: 100 g approx. |
| विवरणहरू | Cable type |
| उत्पादन | Digital Fiber Sensor |
| सामाग्री | Enclosure, Case cover: PolycarbonateSwitch: Polyacetal |
| सहायक उपकरण | FX-MB1 (Amplifier protection seal): 1 set |
| सुरक्षा | IP40 (IEC) |
| भाग नम्बर | FX-505-C2 |
| उत्पादनको नाम | Digital Fiber Sensor FX-500 Ver.2 |
| एनालग आउटपुट | Output current: 4 to 20 mA approx. [H-SP, FAST STD: At 0 to 4,000 digits, LONG: At 0 to 8,000 digits (Note) ]Response time: 2 ms or lessZero point: Within 4 mA plus or minus 1 % F.S.Span: Within 16 mA plus or minus 5 % F.S.Linearity: Within plus or minus 3 % F.S.Load resistance: 0 to 250 Ohm(Note) If display adjustment was conducted, it is not in this range. |
| प्रतिक्रिया समय | H-SP: 25 micro s or lessFAST: 60 micro s or lessSTD: 250 micro s or lessLONG: 2 ms or lessU-LG: 4 ms or lessHYPR: 24 ms or less, selectable |
| बाह्य इनपुट | NPN non-contact input- Signal conditionHigh: +8 V to +V DC or OpenLow: 0 to +1.2 V DC(at 0.5 mA source current)- Input impedance: 10 kOhm approx. |
| उत्पादन नम्बर | FX-505-C2 |
| आपूर्ति भोल्टेज | 12 to 24 V DC+10-15 % Ripple P-P 10 % or less |
| टाइमर प्रकार्य | Incorporated with variable OFF-delay / ON-delay /One-shot / ON-delay - OFF-delay / ON-delay - One-shot timer, switchable either effective or ineffectiveIncorporated with variable OFF-delay / ON-delay /One-shot timer, switchable either effective or ineffective |
| केबल एक्सटेन्सन | Extension up to total 100 m328.084 ftis possible with 0.3 mm2, or more, cable. (however, supply voltage 12 V DC or more) |
| विभिन्न सेटिङहरू | Hysteresis setting / Shift amount setting / Emission power setting / Display turning setting / ECO setting / Data bank loading saving setting / Copying setting / Code setting / Reset setting / Logical calculation setting / Threshold value tracking setting, etc. |
| बिजुली खपत | Normal operation: 960 mW or less (current consumption 40 mA or less at 24 V supply voltage, excluding analog output)ECO mode: 680 mW or less (current consumption 28 mA or less at 24 V supply voltage, excluding analog output) |
| आउटपुट १, आउटपुट २ | NPN open-collector transistor- Maximum sink current: 50 mA (Note 1)- Applied voltage: 30 V DC or less (between output and 0 V)- Residual voltage: 2 V or less (Note 2) (at maximum sink current)(Note 1) 50 mA max. if 5 or more standard types are connected together.(Note 2) 50 mA max. if 5 or more standard types are connected together. (25 mA in case of 2-output type and cable type) |
| परिवेशको तापक्रम | -10 to +55 ℉+14 to +131 ℉[If 4 to 7 units are mounted in cascade: -10 to +50 ℉+14 to +122 ℉or if 8 to 12 units are mounted in cascade: -10 to +45 ℉+14 to +113 ℉] (No dew condensation or icing allowed), Storage: -20 to +70 ℉-4 to +158 ℉ |
| संवेदनशीलता सेटिङ | 2-point teaching / Limit teaching / Full-auto teaching / Manual adjustment |
| टाइमर प्रकार्य: टाइमर अवधि | Timer range ''ms'': 0.5 ms approx., 1 to 9,999 ms approx., 1 ms approx.Timer range ''sec.'': 0.5 s approx., 1 to 32 s approx., 1 s approx.Timer range ''1/10 ms'': 0.05 ms approx., 0.1 to 999.9 ms approx., 0.1 ms approx.each output is set individually |
| उत्सर्जन तत्व (मड्युलेटेड) | Red LED (Peak emission wavelength: 643 nm0.025 mil) |
| सीई मार्किंग निर्देशन अनुपालन | EMC Directive, RoHS Directive |
| उत्सर्जन रकम सेटिङ प्रकार्य | Incorporated, 3 levels (each level 25 to 100 %) + Auto setting [1 level (25 to 100 %) when using H-SP mode] |
| हस्तक्षेप रोकथाम कार्य | Incorporated (Note) , selectable either automatic interference prevention or different frequency(Note) Number of sensor heads which is possible to be mounted closely in auto interference prevention function depends on response time as shown in table below.Number of sensor heads which is possible to be mounted closely in different frequency Interference prevention function is up to 3 units.- Number of sensor heads mountable closely (Unit: set)Response time: IP-1H-SP: 0FAST: 2STD: 4LONG: 8U-LG: 8HYPR: 12 |
| आउटपुट १, आउटपुट २: आउटपुट पोइन्टहरू | 2 points |
| सम्भावित बाह्य इनपुट प्रकार्य | Emission halt / Teaching (Full-auto, Limit, 2-point) / Logic operation setting / Copy lock / Display adjustment / Data bank load / Data bank save, selectable |
| आउटपुट १, आउटपुट २: आउटपुट सञ्चालन | Switchable either Light-ON or Dark-ON by L/D mode |
| घटना प्रकाश तीव्रता प्रदर्शन दायरा | H-SP / FAST / STD: 0 to 4,000LONG: 0 to 8,000U-LG / HYPR: 0 to 9,999 |
| बाह्य इनपुट (आउटपुट २ सँग स्विच गर्न मिल्ने) | - |
| आउटपुट १, आउटपुट २: सर्ट-सर्किट सुरक्षा | Incorporated |
उत्पादन विवरण
FX-500 F Amplifier. Optical, analog output, 2 NPN outputs, dual display, high sensitivity and detection distance, ultra-fast
मुख्य विशेषताहरू
- औद्योगिक स्तरको गुणस्तर
- RoHS अनुरूप
- सीई प्रमाणित
- १-वर्षीय वारंटी
उत्पादन कागजातहरू
डेटासिट
प्राविधिक विशिष्टताहरू र प्रदर्शन डेटा
प्रयोगकर्ता म्यानुअल
स्थापना र सञ्चालन मार्गनिर्देश
