BH4-D230W2-230

Dimmer, 2 x 230 W OutputBH4-D230W2-230Switching and dimming of lamps8 control-channel receiverNegative or positive phase angle dimmingFor DIN-rail mountingLED-indications for alarm, smart-house carrier and outputLamp-protective soft-start functionChannel coding by BGP-COD-BAT4 lighting scenesTransmits the status of the dimming outputProtected against short-circuit and overloadButtons on the front for manual control of the dimmer Switch for selecting scenarios lock/unlock on the frontOutput is shortcircuit /overload protectedOUTPUT SPECIFICATIONSOutputs2Dimming capacity2 x 230 WNote: The 230 W is the total load on the output. Do not use thedimmer with traditional transformers. If the installation uses an electronic transformer, the load is typically 10% on thetransformer and 90% on the lamps.Rated operational voltage 230 VAC ±10% Dimming speed3.6 s (5% - 100%)Response time 1 Cycle:≤ 272 ms @ 128 channels)GENERAL SPECIFICATIONSPower ON delay7 sIndication forSupply On LED, GreenAlarmLED, Red – Flashing Slow flashing: Overload Fast flashing: Short circuitsmart-house carrierLED, YellowOutput On LED, Red (one per output)EnvironmentOperating temperature 0° to +50°C/32° to +122°FHumidity (non-condensing)Max. 85%SUPPLY SPECIFICATIONSPower SupplyRated operational voltage230 VAC ±10% Power consumption 12 VAPower dissipation Max. 3.5 W Frequency50/60 HzWIRING DIAGRAMHousing H4-housingOperating Device Switch for selection of negative/positive phase angle control.Push button switch for turning output “ON/OFF” (one per output).Latching switch for enteringscenario programming mode.Standards IEC 60669, EN 55022/EN 50081-1 and EN 55024/ EN 50082-1DIMENSIONS (mm)D+12VA D-3,5W12345 67821 22 232425262728L N N NL out1L out2Specifications are subject to change without notice (28.09.2010) - A product of the CARLO GAVAZZI Group