B4X-TEMDIS

Aurora Temperature ControllerB4X-TEMDISsmart-house temperature controller with displayDeveloped to fit into wall socket from Fuga, NICO an BticinoShows current room temperatureShows outdoor temperature Turns on/off heating and cooling Set wanted room temperatureEnergy Save through night setback temperature Channel Programming using BGP-COD-BAT The use of floor sensor is optionalDelivered with pre-programmed address on I/O 2Delivered with both white and charcoal grey pushbutton covers Non-activated inputs and backlight indicated by orange light Orange LED can be de-activated by an internal dip switch Activated inputs indicated by blue lightGENERAL SPECIFICATIONSChannel programming By BGP-COD-BAT and special cable: GAP-TPH-CAB. After mounting, reprogramming can be done by removing the slim pushbutton cover and pull the switch element with a a pair of pointed pliers (see drawing next page), and connect the cableto the connector on the back of the switch element.No. of channels2 needed + 3 OptionalChannel assignment I/O 1: Not programmed I/O 2: Pre-programmed to address B2I/O 3: Not programmedI/O 4: Not programmedI/O 5: Not programmed Enclosure Aurora 44 x 44 mechanics EnvironmentDegree of protectionIP 20Pollution degree 3 (IEC 60664)Operating temperature 0° to +50°C (32° to +122°F)Storage temperature -20° to +70°C (-4° to +158°F)Humidity (Non condensing) 20 - 80% Weight 50 g DimensionsAurora (WxHxD) 44 x 44 x 26 mmMax. wire in terminals Max. 2 x 0.75 mm2SUPPLY SPECIFICATIONSPower supply Supplied by smart-houseConsumption (typical)Activated (guidelight OFF)1.5 mA Activated (guidelight ON) 2 mA Not activated (guidelight OFF) 0.6 mA Not activated (guidelightON) 1.1 mATYPE SELECTIONSupply Ordering no.By smart-house busB4X-TEMDISDelivered with both white and charcoal grey pushbutton covers. Frame not included.Floor sensor BSO-TEMDIG is not included.INPUT SPECIFICATIONSSensor 1 integrated temperature sensor Range 0 - 50°C (32 - 122°F)Precision± 1°CFloor sensor (not included) Temperature range 0 - 50°C (32 - 122°F) Cable length 4 mCable consists of 4 wires:Brown Connect to “+” on Temperature controllerWhiteConnect to “c” on Temperature controllerYellow Connect to “d” on Temperature controllerGreenConnect to “T” on Temperature controllerSee wiring diagramThe floor sensor is an active 4-wire sensor and will only work together with the temperature controller unit.Specifications are subject to change without notice (25.09.2009) - A product of the CARLO GAVAZZI Group